30 degree 2 flute with .010 chisel point

10% Cobalt Fine Grain Carbide Engraving Cutter 1/8 dia x 1.5 Long with a 30 degree included angle

Designed for CNC Milling Machines. This cutter has 2 flutes instead of one like the traditional single lip cutter.

It is ready to use out of the box to cut a width .010 inches. Other point sizes are available.

Cuts cleanly leaving no burrs in the following materials:

Stainless Steel (304)
Hardened steels too!

Special compound point delivers a cutter that can handle a wide range of materials without breaking and leave a burr free surface.

Engraving cutters work best at 10K to 20K RPM. This cutter will work fine with a .0005 chip load at lower speeds too. The dual lip design and strong point make this cutter last longer and cut faster than traditional single lip cutters.

Return to the products page for how to purchase.